Electrolux ARCTIS 818 35 94-01/2 - Manual (Page 20)

20 818 35 94-01/2
Select "Freezing" or "Cooling"
If necessary, switch over the appliance with the following steps
between the operating modes "Freezing" and "Cooling":
0
1. Hold down the ALARM OFF button and the „-“ (COLDER) button simul-
taneously for 5 seconds.
• When the setting is switched from “Freezing” to “Cooling” “FC”
(Freezing -> Cooling) appears in the temperature display, an acoustic
signal confirms the change and the temperature display changes to
flashing figures (DESIRED temperature cooling mode +5 °C). Using
the temperature setting buttons, the required temperature for the
cooling mode can now be entered.
• When the setting is switched from “Cooling” to “Freezing” “CF” (Cool-
ing -> Freezing) appears in the temperature display, an acoustic sig-
nal confirms the change and the temperature display changes to
flashing figures (DESIRED temperature freezing mode -18 °C). Using
the temperature setting buttons, the required temperature for the
freezing mode can now be entered.
3 The operation mode, in which your appliance is at the moment, is
identifiable if the temperatures can be set above or below 0 °C.
2. Set the temperature depending upon the selected operation mode (see
the chapter "Temperature Adjustment").
Attention! If you are using the appliance as a freezing unit: Please wait
prior to putting the foodstuff to be frozen, until the freezer interior
temperature has attained -18 °C, or until the red warning display goes
off.
Attention! If you are using this appliance as a cooling unit, after it has
been used as a freezing unit: Please wait until the temperature has
reached 0 °C before putting the foodstuff to be cooled in the appliance.
Temperature Adjustment
0
1. Press either the „+“ (WARMER) or „-“ (COLDER) button.
The temperature display switches over and the DESIRED temperature
currently set flashes on the temperature display.
2. To adjust to a warmer temperature, press the „+“ (WARMER) button. To
adjust to a colder temperature, press the „-“ (COLDER) button. The
changed setting is immediately displayed on the temperature display.