Electrolux ARCTIS 818 35 94-01/2 - Manual (Page 32)

32 818 35 94-01/2
Replacing the light bulb
1
Warning! Danger of electrical shock! Before replacing the light bulb
switch appliance off and remove the mains plug, or switch off or
disconnect from the electricity supply.
Light bulb specifications: 220-240 V, max. 25 W, socket: E 14
0
1. To switch the appliance off press
and hold the ON/OFF button for
approximately 1 second.
2. Remove mains plug.
3. For replacement of the light bulb
press the cover and remove it like
shown on the illustration.
4. Replace defective light bulb.
5. Place the cover again.
Regulations, Standards, Guidelines
This appliance was designed for household use and was manufactured
in accordance with the appropriate standards. The necessary measures
in accordance with appliance safety legislation regulations (GSG), acci-
dent prevention regulations for refrigeration appliances (VBG 20) and
the regulations of the German Society of Electrical Engineers (VDE)
were observed in the manufacture of this appliance.
The refrigerant circuit has been checked for leaks.
Only temperatures above
0 °C can be set, although
the appliance should be
used as a freezing unit.
The appliance is in the
operation mode "Cooling".
Selecting the operation
mode "Freezing". For that,
please refer in the "Select
Freezing or Cooling"
chapter.
Only temperatures below
0 °C can be set, although
the appliance should be
used as a cooling unit.
The appliance is in the
operation mode "Freezing".
Select the operation mode
"Cooling". For that, please
refer in the chapter "Select
Freezing or Cooling".
Malfunction Possible cause Remedy