Emulex EMULEX - Manual (Page 23)

FCA Utilities Reference Manual Page 19
dynamic: no
desc: Select Fibre Channel topology
-----------------------------------------------------------------
label: link-speed
min: 0
current: 0
max: 4
default: 0
dynamic: no
desc: Select link speed
-----------------------------------------------------------------
label: num-nodes
min: 2
current: 512
max: 512
default: 512
dynamic: no
desc: Number of fibre channel nodes (NPorts) the driver will support.
-----------------------------------------------------------------
label: cr-delay
min: 0
current: 0
max: 63
default: 0
dynamic: no
desc: A count of milliseconds after which an interrupt response is generated
-----------------------------------------------------------------
label: cr-count
min: 1
current: 1
max: 255
default: 1
dynamic: no
desc: A count of I/O completions after which an interrupt response is
generated
-----------------------------------------------------------------
label: assign-alpa
min: 0x0
current: 0x0
max: 0xef
default: 0x0
dynamic: no
desc: Assigns a preferred ALPA to the port. Only used in Loop topology.
-----------------------------------------------------------------
label: adisc-support
min: 0
current: 1
max: 2
default: 1
dynamic: yes
desc: Sets the Fibre Channel ADISC login support level.
-----------------------------------------------------------------
label: pm-support
min: 0
current: 1
max: 1
default: 1
dynamic: no
desc: Enables power management support.
parm_get <label>
Gets the value of a specified parameter in the driver.