Efficient Networks SpeedStream 5100 Series - Manual (Page 27)

SpeedStream Router User Guide
19
Customizing Router Settings
This section provides you with the information and procedures to customize various settings on your
SpeedStream router. Many of these procedures require a mid- to advanced-level understanding of
networking principles. If unsure, contact your Service Provider for assistance.
Host
The Host Configuration screen allows you to change the host IP address, netmask, default router and
host name. The information in this section is auto-generated and should not be changed unless your ISP
directs you to do so; for example, if you have been assigned a static IP address.
To specify the host configuration settings:
1. If your ISP has assigned a static IP address for this machine, enter that IP address and subnet mask.
2. Enter the default router address if other
than that specified.
3. Enter the host name if other than
speedstream.
4. Click Save Settings.
A confirmation screen displays
notification that the new setting will not
take effect until you reboot the router.
You may do so at this point or later.
5. To reboot the router, click Reboot on the confirmation screen.
The System Reboot screen displays with a countdown while the router is rebooting. When finished,
the System Summary screen displays.
DHCP
DHCP, the Dynamic Host Configuration Protocol, describes the means by which a system can connect to
a network and obtain the necessary information for communication upon that network. The information in
this section is auto-generated and should not be changed unless your ISP directs you to do so; for
example, if you have been assigned a static IP address.
IP Address Restrictions
Certain restrictions apply to the range of IP addresses specified by the parameters Start IP Range, End
IP Range, and IP Netmask defined above. These restrictions are as follows: