Enviro Kodiak 1200 Fireplace Freestanding - Manual (Page 46)

Figure 59: Changing
decorative plate.
Installation
R
EMOVAL
O
F
T
HE
S
HROUDS
- I
NSERT
:
A
B
B
1. If the surround panel is installed, remove it by lifting the panel straight
up then out.
2. For the right shroud, twist the handle on the air control clockwise to
remove it from the rod.
3. Pull unit forward a few inches, if possible.
4. Remove the screw, using a
5 /
16
” socket or wrench, that goes down
through the firebox top into a bent over tab at the top of the shroud
(see A in Figure 58).
5. The shrouds can be removed one of two ways:
a. For the first method, pull the inside edge of the shroud straight
out, approximately 3⁄4” (2cm), in order to unhook the shroud from
unit. Pull the shroud out through the side.
b. For the second method (recommended for the right shroud),
remove the two (2) T-20 screws that hold the shroud to the unit
(see B in Figure 58). Pull the shroud out through the side.
6. To install the shroud, follow steps 1 through 5 in reverse order. Ensure
the shrouds are hooked behind both screws on either side.
Figure 58: Removal of right
pod.
Vibration
Bumper
I
NSTALLATION
O
F
T
HE
D
ECORATIVE
P
LATES
- I
NSERT
:
1. Remove the shroud from the unit (refer to “R
EMOVAL
O
F
T
HE
S
HROUDS
-
I
NSERT
”)
2. Remove the fan from the left shroud (refer to ”F
AN
R
EMOVAL
- I
NSERT
”)
3. Unfasten the two (2) nuts that secure the plate to the shroud. The nuts
should only be hand-tightened but a 5 /
16
” wrench may be required.
4. Remove the old plate from the shroud and remove the vibration bumper
from the plate. Leave the washers on the shroud.
5. Install the vibration bumper into the new decorative plate and install
new plate onto the shroud.
6. Hand-tighten the two (2) nuts back into place.
7. Re-install the fan into the left shroud.
8. Re-install the shrouds onto the unit.
Note: The left decorative plate has rectanglular holes and the right
decorative plate does not.
46