EverFocus EQ600 WDII - Manual (Page 2)

Safety Warning
1. Read manual carefully before installing the unit.
Please read this manual first for correct installation and operation.
2. Never install the camera on a ceiling that cannot hold its weight
The product may fall down to cause damages.
3. Do not install the camera near electric or magnetic fields.
Installed the camera away from TV, radio transmitter, magnet, electric motor, transformer, audio
speakers because the magnetic fields generate from above devices will distort the video image.
4. Always stop using when the product emits smoke or abnormal heat
5. Never disassemble the camera nor put impurities in it
Disassembly or impurities may result in trouble or fire.
6. Never face the camera toward the sun.
Direct sunlight or severe ray may cause fatal damage to sensor and internal circuit.
7. Keep the power cord away from wet and never touch the power cord with wet hands.
Touching the wet power cord with hands or touching the power cord with wet hands may result in
electric shock.
8. Never install the camera in areas exposed to water, oil or gas.
The water, oil or gas may result in failure, electric shock or file.
9. Cleaning
Do not touch the surface of sensor by hand directly. Use a soft cloth to remove the dirt from the
camera body. Use lens tissue or a cotton tipped applicator and ethanol to clean the sensor and the
camera lens.
10. Do not operate the camera beyond the specified temperature, humidity or power source
ratings.
Use the camera at temperatures within 0℃ ℃ ℃ ℃ ~ 40℃ ℃ ℃ ℃ and humidity below 90%. The input power
source is DC12V/AC24V.
Notice:The information in this manual was current when published. The manufacturer reserves the
right to revise and improve its products. All specifications are therefore subject to change without notice.