Enterasys Networks VH-2402S - Manual (Page 18)

4 Product Overview VH-2402S
Front Panel
Figure 1-1 shows the front panel of the Enterasys Networks Vertical
Horizon VH-2402S. Table 1-1 defines the VH-2402S front panel
components.
Figure 1-1. VH-2402S Front Panel
Table 1-1. Front Panel Components
Name Function
Power LED Lights steady green to indicate power is supplied to the
switch. Off indicates no power is supplied to the switch.
RDP LED Lights steady to indicate that a redundant power unit is
attached and is in backup or active mode.
Mgmt LED Lights steady to indicate that a Management Module is
installed and in operational mode.
Link LEDs Yellow indicates a 10 Mbps link; green indicates a 100
Mbps link, off indicates no link; and flashing indicates
that the port has been manually disabled.
Mode LEDs The Mode Select button selects the LED display mode.
Act: Flashing indicates activity on the port segment.
FDX: Lights steady to indicate full-duplex operation.
Flow Ctrl: Lights steady to indicate that flow control is
enabled for the port.
Module LEDs Status: Indicates a module is installed in the slot.
Activity: Flashing indicates activity on the module.
Switch ID LCD LCD displays the stack ID number of the switch.
10Base-T/100Base-TX
RJ-45 ports Copper ports using RJ-45 port connectors. All the ports
are wired MDI-X.