Exmark Lazer Z XP - Manual (Page 11)

- 6 -
1.4.17 DO NOT mow with the discharge deflector raised, removed, or altered unless
there is a grass collection system or mulch kit in place and working properly.
1.4.18 Be Aware of the mower discharge and direct discharge away from others.
1.4.19 DO NOT operate the mower under the influence of alcohol or drugs.
1.4.20 Use extra care when approaching blind corners, shrubs, trees or other objects
that may obscure vision.
1.4.21 If jump starting is required:
a) connect the positive (+) power cable from the positive post on the booster
battery to the positive post on the battery.
b) connect the negative or ground cable (-) from the negative post on the
booster battery to the engine block as far away from the battery as possible.
c) disconnect battery cables in the reverse order after starting.
1.5 MAINTENANCE AND STORAGE
1.5.1 For engine maintenance, follow the engine manufacturer’s recommendations
precisely as stated in the engine manual.
1.5.2 Disconnect the battery cable from the negative battery post when the unit will be
allowed to sit for more than 30 days without use.
1.5.3 Allowing batteries to stand for an extended period of time without recharging
them will result in reduced performance and service life. To preserve optimum
battery performance and life, recharge batteries in storage when the open circuit
voltage drops to 12.4 volts.
Note: To prevent damage due to freezing, battery should be fully charged before
putting away for winter storage.
1.5.4 Keep engine and engine area free from accumulation of grass, leaves, excessive
grease or oil, and other debris, which can accumulate in these areas. These
materials can become flammable and may result in a fire.
1.5.5 Store fuel in a container specifically designed for this purpose in a cool, dry place.
1.5.6 Keep the mower and fuel container in locked storage to prevent children from
playing or tampering with them.
1.5.7 Gasoline or diesel fuel powered equipment or fuel containers should not be stored in
a basement or any enclosed area where open pilot lights or heat appliances are
present.
1.5.8 Maximum mowing results and safety can only be achieved if the mower is
properly maintained and operated correctly.
1.5.9 Check all bolts frequently to maintain proper tightness.
1.5.10 Keep all guards, shields, and all safety devices in place and in safe working
condition.
1.5.11 Frequently check for worn or deteriorating components that could create a hazard.
1.5.12 All replacement parts must be the same as or equivalent to the parts supplied as
original equipment.