Exmark Lazer Z XP - Manual (Page 30)

- 25 -
DO NOT attempt to turn the unit while on the ramp, you may lose control and
drive off the side.
Avoid sudden acceleration when driving up a ramp and sudden deceleration
when backing down a ramp. Both maneuvers can cause the unit to tip backward.
5. MAINTENANCE & ADJUSTMENTS
WARNING
POTENTIAL HAZARD
♦ While maintenance or adjustments are being made,
someone could start the engine.
WHAT CAN HAPPEN
♦ Accidental starting of the engine could seriously injure
you or other bystanders.
HOW TO AVOID THE HAZARD
♦ Remove the key from the ignition switch before you do
any maintenance.
WARNING
POTENTIAL HAZARD
♦ The engine can become very hot.
WHAT CAN HAPPEN
♦ Touching a hot engine can cause severe burns.
HOW TO AVOID THE HAZARD
♦ Allow the engine to cool completely before service or
making repairs around the engine area.
5.1 PERIODIC MAINTENANCE
5.1.1 Check engine oil level:
Service Interval: Daily
a) Stop engine and wait for all moving parts to stop. Make sure machine is on
a level surface.
b) Check with engine cold.
c) Clean area around dipstick. Remove dipstick and wipe oil off. Reinsert the
dipstick and push it all the way down into the tube. Remove the dipstick
and read the oil level.
d) If the oil level is low, wipe off the area around the oil fill cap, remove cap
and fill to the “FULL” mark on the dipstick. Use oil as specified in Engine
Owner’s Manual. DO NOT
overfill.
IMPORTANT: DO NOT operate the engine with the oil level below the
“LOW” (or “ADD”) mark on the dipstick, or over the “FULL” mark.
5.1.2 Check engine coolant level
Service Interval: Daily
a) Stop engine and wait for all moving parts to stop. Make sure machine is on
a level surface.
b) Tilt seat up and tilt hood forward to gain access to the cooling area.
c) Check with engine cold.
d) View coolant level in overflow bottle on the left side of the engine. Coolant
level should be at the indicator line on the overflow bottle.