Electra Accessories 88969 - Manual (Page 17)

16
STARTING INSTRUCTIONS
First, be sure there is pre-mixed gasoline the gas tank. If unsure about the gasoline mixture, refer
to the Gasoline/Oil Mixing Instructions section. Make sure both fuel lines are properly attached
to the carburetor. There is one main fuel line (black) and one primer bulb line (clear). If these
lines are not properly attached, the engine will not run.
1. Make sure battery is fully charged (see battery charging instructions)
*When using the electric starter feature, the battery on the GAS CHOPPER SCOOTER™ must
be fully charged. To understand how to charge your battery, please see CHARGING THE
GAS CHOPPER SCOOTER™ BATTERY section.
2. Make sure ignition key is in ON position.
3. You will first need to prime the engine with fuel. The primer ball is located on the carburetor,
which is on the front of the engine. (Fig. 1)
4. Pump the primer ball approximately 10 to 15 times, or until fuel is completely visible all
throughout the clear fuel line.
5. Pull the choke lever up, to the "ON" position. (Fig. 2)
Proceed to start the engine using either the Pull Start (Fig. 3)
or the Electric Start (Left brake lever must be engaged with Electric start feature) (Fig. 4)
*If engine does not start with choke Up/On, attempt to start with choke lever on Down/Off position
WHEN USING THE ELECTRIC STARTER FEATURE, THE LEFT BRAKE HANDLE MUST BE ENGAGED!
FAILURE TO ENGAGE THE LEFT BRAKE LEVER WILL NOT ALLOW THE GAS CHOPPER SCOOTER™
TO START USING THE ELECTRICAL STARTER FEATURE!
6. Once the engine starts, allow it to run on its own and warm up for a few minutes. After a few
minutes push choke lever to Down/Off position.
HAVING TROUBLE STARTING YOUR GAS CHOPPER SCOOTER™ ? See our trouble shooting tips
in this manual or call our Techline: 1-888-467-1234 M-F 10am - 9pm EST.
Choke Lever
Up/On
Down/Off
Fig. 2
Fig. 3
Pull Start
Fig. 1
Primer Ball
Fig. 4
Electric Starter Button