Electrolux U31216 EHG 7812 - Manual (Page 22)

22 electrolux
Seal Seal Seal Seal Seal
Fitting the Hob into the Worktop
Carry out the building in of the hob as follows:
1. place the seals supplied with the hob on the front edge of the cut
out. Then, place them at 86 mm from the side edges and at 10
mm from the rear edge, as
shown in the diagram, taking
care that the seals meet
without overlapping.
2. Place the hob in the cut out,
taking care that it is centred.
3. Fix the hob with the relevant
fixing clamps, supplied with
the injectors kit (see diagram).
When the screws have been
tightened, the excess seal can
be removed.
The edge of the hob forms a double
seal which prevents the ingress of
liquids.