Correct use of chain brake, Spark arrestor muffler – Echo CS-310 User Manual

Page 11

Advertising
background image

11

CS-310

SPARK ARRESTOR MUFFLER

• The spark arrestor muffler controls the exhaust

noise and prevents hot, glowing particles of

carbon from leaving the muffler.

Make sure the spark arrestor screen is in good

repair and properly seated in the muffler.

• Certain internal combustion engines operated on

forest, brush, and/or grass-covered areas in the

states of Washington, Oregon, Idaho, California,

Minnesota, New Jersey and Maine, are required

to be equipped with a spark arrestor.

CORRECT USE OF CHAIN BRAKE

Liner kickback

Rotational kickback

Chain moving downward at impact

Rotational kickback

Reduced

radius

Pinch

Kickback

This requirement also applies to all U.S. Forest

Service lands.

In some of these areas, the spark arrestor system

must be certified per USDA Forest Service Regula-

tion SAE J335.

Check with your local or state authorities for spe-

cific regulations in your area.

Failure to follow these requirements is a violation

of the law.

DANGER

Kickback safety precaution for chain saw users:

Kickback may occur when the nose or tip of the

guide bar touches an object or when the wood

closes in and pinches the saw chain in the cut.

The installation of a chain brake may be mandatory

by law or as stipulated by insurance regulations in

your area of operation.

You should inquire through local government of-

fices, your employer or your local dealer to ensure

that your chain saw conforms to the required safety

standard.

ECHO chain brakes have been designed and

tested to comply with international safety standards

as follows.
USA

: ANSI Standard B175.1 - 2000

Safety Requirement for chain saws

Canada : CSA Standard Z 62.1 CHAIN SAWS

WARNING

ANSI Standard B175. 1 - 2000 stipulates that

the brake shall stop the chain 0.12 seconds

at an engine speed of 13500 r/min.

It is the responsibility of the owner/operator

to ensure that the brake is serviced, adjusted

and tested strictly in accordance with the

instructions as detailed herein in order

to ensure that the brake performance is

maintaind in compliance with the Standard

B175. 1 - 2000.

Advertising