Epson ELPMB27 - Manual (Page 12)

12
Assembly and Installation
Make sure you follow the instructions below to install the wall mount. Otherwise, the wall mount may fall and result in
personal injury or property damage.
1. Installing the wall plate
1) Check the position where you want to install the wall plate, and then mark that position on the wall.
As shown in the illustration below, set the horizontal center of the wall plate 8 cm (3.14 inches) to the left of the
horizontal center of the whiteboard. Allow at least a 5 cm (1.96 inches) gap between the top of the whiteboard and the
bottom of the wall plate. However, if you are using the maximum (tele) screen size, refer to the tables on the previous
pages.
After installing, you can slide the projector horizontally 4.5 cm (1.77 inches) by using the slider on the adjustment unit.
See step 10 on page 18 for more details.
q
At the point where the wall mount is installed, make sure there is a gap of 410 to 660 mm (16 to 26
inches) from the top of the image projected onto the white board to the ceiling. See "Screen Size and
Projection Distance" on page 7 for more details.
❏ When you mount the projector on the wall with the wall mount, the wall requires enough strength to hold
the projector, optional accessories, and the wall mount. This wall mount should be installed on a concrete
wall. Confirm the weight of the projector, optional accessories, and the wall mount before installation, and
maintain the strength of the wall. If the wall is not strong enough, reinforce the wall before installation.
❏ The combined weight of this mount and the projector is approximately 15.5 kg (34.18 lbs.) maximum.
Before starting the installation, carefully check the construction, material, and strength of the wall.
❏ Install the mount firmly to hold the weight of the projector and the mount, and to resist horizontal
vibration. Use M8 nuts and bolts. Nuts and bolts smaller than M8 could cause the mount to fall.
❏ Epson accepts no responsibility for any damage or injury caused by lack of wall strength or inadequate
installation.
Warning
Center of the whiteboard
Center of the wall plate
5 cm
8 cm