Extron Electronics MAV 62 - Manual (Page 7)

MAV 62 Matrix Switcher • Installation MAV 62 Matrix Switcher • Installation
Installation, cont’d
2-3
(2) 4-40 x 3/16" Screws
Use 2 mounting holes on
opposite corners
False Front panel
uses 2 front holes
6 x 2 S -VID EO AN D A UD IO M AT RIX
MA V 6 2 S -VID EO AN D A UD IO
Figure 2-1 — Rack mounting the switcher
7 5 4
1 3 6
2
Figure 2-2 — MAV 62 S-video cabling
7 5 4
1 3 6
2
Figure 2-3 — MAV 62 composite video cabling
Installation
Installation Overview
To install and set up an Extron MAV 62 switcher for operation,
follow these steps:
1 Turn off all of the equipment. Ensure that the video
sources (DVD players, laserdisc players, VCRs, satellite
receivers, or other devices) and the output display are all
turned off and disconnected from the power source.
2 Mount the switcher. See Mounting the switcher in this
chapter.
3 Attach the cables. See Rear Panel Cabling in this chapter.
4 Connect power cords and turn on the display devices and
the input devices.
5 Set the audio gain and attenuation. See Front Panel
Controls and Indicators in chapter 3.
Mounting the switcher
1 . For optional rack mounting, mount the MAV switcher on
the left or right side of a 19" 1U Universal Rack Shelf
(Extron part #60-190-01) (figure 2-1).
a . If feet were previously installed on the bottom of the
case, remove them.
b . Mount the switcher on the rack shelf, using two
4-40 x 3/16 screws in opposite (diagonal) corners to
secure the case to the shelf.
2 . If desired, attach a false front panel, or a second ½-rack-
width device to the other side of the shelf.
3 . Attach the rack shelf to the rack using four 10-32 x ¾” bolts
and four #10 beveled dress washers.
Rear Panel Cabling
All connectors are on the rear panel. Depending on the model
of the switcher, the type and layout of the connectors on the rear
panel will vary. Figure 2-2 shows the rear panel of the MAV 62
S-video switcher. Figure 2-3 shows the rear panel of the MAV 62
composite switcher.
Signal input connections
1
S-video input connectors — Connect S-video sources to these
4-pin mini DIN connectors.
2-2