Remote control instructions – Element Electronics 32LE30Q User Manual
Page 13
Using the remote control – Remote control instructions
12
REMOTE CONTROL INSTRUCTIONS
< Inserting the batteries into the remote control >
1.
Push the back of the remote control.
2.
Pull forward slightly.
3.
Insert two AAA 1.5V batteries.
4.
Ensure the correct polarity (+/-).
5.
Close the lid.
CAUTION: Use only Alkaline Batteries.
z If the remote control is not working, see the checkpoints below.
z Are the polarities of the batteries (+, -) correct?
z Are the batteries worn out?
z Is there an AC power failure?
z Is the power cable plugged in?
z Is any special fluorescent or neon sign board turned on?
< Remote Control Reception Angle>
Use the Remote control within a range of 7~10m and at an angle of 30° to either side of the receiver.
CAUTION
z Used batteries should be recycled.
z Kept out of children's reach.
z Do NOT use new and old batteries together.
z Change both batteries at the same time.
z When not using the remote control over a long time, remove the batteries from the unit.
z Use only Alkaline battery.