Basic operation – choosing tv channel, Turning on and off the tv, Choosing tv channel – Element Electronics 32LE30Q User Manual
Page 14
Basic operation – Choosing TV Channel
13
TURNING ON AND OFF THE TV
TURN ON LCD TV
1. Connect the AC input cable to power to the LCD TV. At this time the TV will enter standby mode and indicator show red.
2. User
POWER button or
button on the remote control.
3. Wait 5 second after switch off LCD TV then you can turn on LCD TV again.
CHOOSING TV CHANNEL
1.
Using the CH + / CH - on the front panel or on the remote control.
z
Press CH + to increase channel number.
z
Press CH - to decrease channel number.
2.
Using 0-9 digital buttons and – button
You can select the channel number by pressing 0 to 9.
3. For
example:
IN ANALOG SIGNAL:
To select channel (e.g. Channel 22): Press 2 -> 2 ->ENTER,It will jump to 22-0 directly.
IN DIGITAL SIGNAL:
To select digit channel (e.g. Channel 22-1): Press 2 -> 2 -> - > 1 ->ENTER,the program will appear immediately.
NOTE: Sub channel number of analog channel is always zero. But when you in the digital signal, if you enter
physical channel number and not end with “ENTER”, channel selection will be made if there is no
operation within a few seconds.