Ericsson M-PATM SERIES LBI-38377E - Manual (Page 14)

T99 Type 99 tone decode - On indicates Type
99 tone decoding is enabled on the se-
lected channel. Flashing indicates a T99
selective call has been received and the
radio must be reset to receive another
T99 call.
TX Transmitter enabled - On when the radio
is transmitting.
BSY BuSY - On indicates a carrier is being
received (the channel is busy). Note that
if the selected channel is programmed for
Channel Guard (CG), Digital Channel
Guard (DCG), or Type 99 (T99) tone de-
code operation, the radio will not un-
squelch if a valid tone or code is not
received; the BSY status flag will be on.
CG Channel Guard - On indicates tone Chan-
nel Guard (CG) or Digital Channel Guard
(DCG) encode/decode is enabled on the
selected channel.
BAT BATtery low - On indicates the battery
pack’s charge is low.
The following status flags are for use with
Scan and System model radios:
S Scan list - On indicates the selected chan-
nel is on the scan list.
1 priority 1 - On indicates the selected chan-
nel is designated as the priority-one scan
channel.
2 priority 2 - On indicates the selected chan-
nel is designated as the priority-two scan
channel.
SCN SCaN mode - On indicates the radio is
scanning.
UNIVERSAL DEVICE CONNECTOR
The Universal Device Connector (UDC) is lo-
cated on the side of the radio just above the PTT and
MONITOR BUTTONS. This connector provides con-
nections for the external accessories such as a head-
set, a speaker-mike, or an emergency lanyard. When
the radio is locked in a vehicular charger/repeater the
UDC provides the audio and control connections
between the radio and the vehicular charger/re-
peater. The UDC is also used by the maintenance
personnel when the radio is programmed.
14