Extron electronic IPI 100 Series - Manual (Page 14)

IPI 100 Series, IPI 200 Series • Introduction
Introduction, cont’d
1-4
Features
• Two-way, half-duplex voice communications over an IP
network
• Compatibility with IP Intercom-enabled MLC 226 IP
MediaLink Controllers (IPI 101 AAP and IPI 104 AAP)
• Backlit, configurable Push To Talk buttons
• Integrated speaker and microphone
• Three-position switch to adjust speaker volume levels (IPI 101
AAP and IPI 104 AAP only)
• LED indicator to show when the room is being monitored
• Four space and 2-gang Architectural Adapter Plate (AAP)
opening mounting
• Connection via existing network cable drops (one drop per
MLC-IPI pair, IPI 101 AAPs and IPI 104 AAPs, only)
System Requirements
The IP Intercom HelpDesk software is available at no charge via
the Extron Web site (http://www.extron.com) or the CD that
comes with your IPI. To install and run IP HelpDesk, you need
a PC with the following things installed:
• Windows 2000 or Windows XP Professional
• Pentium 4, 2 GHz or faster microprocessor
• 500 MB RAM, recommended (256 MB minimum)
• 50 MB or more available hard disk space
• Windows-supported sound card, microphone, and speakers
• Microsoft Direct X version 9.0c or later
• Microsoft .NET framework, version 2.0 or later
• network card and a network connection
INTERCOM MIC ON
IPI 204
PUSH TO TALK
1 2 3 4
ROOM
101
LAB ADMIN
OFFICE
HELP
DESK
CONFIG
IPI 204 Extron
INTERCOM
MIC ON
IPI 204
PUSH TO TALK
1 2 3 4
ROOM
101 LAB ADMIN
OFFICE
HELP
DESK
CONFIG
INTERCOM MIC ON
IPI 201
PUSH TO
TALK
HELP
DESK
CONFIG
IPI 201 Extron
INTERCOM
MIC ON
PUSH TO
TALK
HELP
DESK
CONFIG