Extron electronic IPI 100 Series - Manual (Page 20)

IPI 100 AAP, IPI 200 AAP Series • Installation
Installation, cont’d
2-6
IPI Rear Panel Features and Cabling
Ä
Intercom port (IPI 101 AAP and IPI 104 AAP only) — This port
is used for power, control, and voice data communication with
the MLC. Plug one end of a standard, straight through, CAT 5,
CAT 5e, or CAT 6 cable terminated with RJ-45 connectors into
this port. Plug the other end of the cable into the Intercom
connector on the MLC 226 IP’s rear panel, as shown in the
following figure.
N A 12” (30.5 cm) CAT 6 cable is included with each IPI. If
you choose to terminate your own cable, the cable must be
no longer than 100’ (30.4 m).
Cables must be terminated to the T586A or T586B
standard and both ends of a cable must be wired to the
same standard.
HOST
CONTROL
R
1=DIGITAL I/O
2=Tx 3=Rx 5=GND
38400, N, 8, 1
PRESS TAB WITH
TWEEKER TO REMOVE
INTERCOM
A
UDIO OUT
LAN
IPI 101 AAP or IPI 104 AAP
Rear Panel MLC 226 IP Rear Panel
<100’ (30.4 m)
POWER RELAY
C NO
AUDIO OUT
LAN
Power
Contact
Relay
Audio Out
IPI 104 AAP, IPI 101 AAP
Rear Panel
AAP Mounting Screws (4)
Intercom Port 1a
2
IPI 204 AAP, IPI 201 AAP
Rear Panel
LAN Port 1b
AAP Mounting Screws (4) 2
3
4
5