Password information, Error responses, Password information -3 error responses -3 – Extron electronic IPI 100 Series User Manual
Page 61
IPI 100 Series, IPI 200 Series • SIS Programming and Control
5-3
(c)Copyright 2007, Extron Electronics, IPI 201 V1.00, 60-809-00
]
Mon Day, DD Mon YYYY HH:MM:SS
(c)Copyright 2007, Extron Electronics, IPI 204, V1.00, 60-810-00
]
Mon Day, DD Mon YYYY HH:MM:SS
Vx.xx is the firmware version number.
The IPI sends the boot and copyright messages under the
following circumstances:
• If the IPI is off and an RS-232 connection is already set up
(the PC is cabled to the IPI 204 series and a serial terminal
emulation program such as HyperTerminal is open), the
connected unit sends these messages via RS-232 when it is
first powered on.
• If the IPI is on, it sends the boot and copyright messages
when you first open a Telnet connection to the IPI. You
can see the day of the week, date, and time if the IPI is
connected via Telnet, but not via RS-232. If you are using a
Telnet connection, the copyright message, date, and time are
followed by a password prompt.
Additional messages may be sent by the IPI in response to front
panel selections and volume adjustments and when scripts are
executed during scheduled events.
Password information
The “
]
Password:” prompt requires a password (administrator
level or user level) followed by a carriage return. The prompt is
repeated if the correct password is not entered.
If the correct password is entered, the unit responds with
“
]
Login Administrator
]
” or “
]
Login User
]
”, depending
on the password entered. If passwords are the same for both
administrator and user, the unit will default to administrator
privileges.
Error responses
When the IPI receives a valid SIS command, it executes the
command and sends a response to the host device. If the IPI is
unable to execute the command because the command is invalid
or it contains invalid parameters, it returns an error response to
the host.
The error response codes and their descriptions are as follows:
E12 – Invalid port number
E13 – Invalid value (the number is out of range/too large)
E14 – Not valid for this configuration