Extron electronic IPI 100 Series - Manual (Page 64)

IPI 100 Series, IPI 200 Series • Programming and Control
IPI 201/204 SIS ™ Programming, cont’d
5-6
the pipe character. With the Web browser, you are required
to use a “W” command and the pipe character.
In either method, {Data} = data that will be directed to a
specified port and must be hex encoded if non-alphanumeric.
N If you make adjustments (changes to volume, etc.), whether
via the front panel or via RS-232 or IP communication, it
will take 1 minute 40 seconds (100 seconds) for the data in
the IPI 200 series’ RAM to be saved to flash memory.
Symbol definitions
]
= CR/LF (carriage return/line feed) (hex 0D 0A)
}
= Carriage return (no line feed, hex 0D)
(use the pipe character,
|
, instead for URL-encoded commands)
• = Space character
|
= Pipe (vertical bar) character
E
= Escape key (hex 1B)
(use W instead of Esc for Web browsers)
X@
= Command data section.
N For Web encoding only: data will be directed to the specified
port and must be encoded (URL encoding) if it is non-
alphanumeric. Change any non-alphanumeric character (%,
+,
|
,
}
, etc.) within the data section into the corresponding
hexadecimal equivalent, %xx, where xx represents the two-
character hex byte. For example, a space (hex: 20) would be
encoded as %20 (hex: 25 32 30) and a plus sign (hex: 2B)
would be encoded as %2B or hex 25 32 42.
X#
= Greenwich Mean Time (GMT) offset value
(-12.00 to +14.00) represents the time difference in hours and
minutes (+/-hh:mm) relative to Greenwich, England. The leading
zero is optional. For example, 5:30 = 05:30. Do not use a plus (+)
sign if the GMT offset is positive.
X%
= On/off status
0 = off / disable
1 = on /enable
X1!
= Version (typically listed to two decimal places, e.g., x.xx)
X1@
= IPI 200 series’ name. The name is a text string of up to 24 characters
drawn from the alphabet (A-Z), digits (0-9), and minus sign/
hyphen (-). No blank or space characters are permitted as part of
a name. No distinction is made between upper and lower case.
The first character must be a letter. The last character must not be
a minus sign/hyphen.
X1#
= Local date and time format
Set format (MM/DD/YY-HH:MM:SS).
Example: 01/18/05-10:54:00.
Read format (day of week, date month year HH:MM:SS). Example:
Tue, 18 Jan 2005 18:19:33 .