Euro-Pro GC130HS - Manual (Page 8)

Operating Instructions
HOW TO OPERATE
Using the Dust Inlet
1. Ensure vacuum bag and filters are
in place before using.
2. Plug unit into outlet. Check that the
power cord is not damaged or wet
before use.
3. Push the power button to turn on the
unit. When the unit has been turned
on, the power indicator light will go
on. (Fig. 5) Once the unit is on,
sweep the dirt/dust to the dust inlet.
The dust inlet will then suck up the
dirt/dust. To turn the unit off, push
the power button a second time.
Using the Central Vac System
1. Ensure vacuum bag and filters are
in place before using.
2. Remove dust inlet cover and insert
hose into suction intake. (Fig. 6)
DO NOT LEAVE UNIT UNATTENDED WHEN IN USE.
WARNING: FULLY ASSEMBLE UNIT BEFORE OPERATING.
3. Attach desired accessory to hose.
Attach extension tubes as
necessary.
• Dusting Brush
Use on furniture, drapes, and
walls.
• Crevice Tool
Use on furniture and between
cushions.
• Small Turbo Brush
Use on furniture.
• Floor Turbo Brush
Use on floors or carpets.
4. Once having attached the desired
accessory, you may push the power
button to turn the unit on and start
the suction. To stop suction push
the power button once more.
Fig. 6
Dust
Inlet
Cover
Suction
Intake
WARNING: NEVER OPERATE THE VACUUM WITHOUT THE
VACUUM BAG AND ALL THE FILTERS IN PLACE
6
Fig. 5
Power
Button
Power
Indicator
Light
Bag and Filter Instructions
VACUUM BAG
How to Remove and Replace the
Vacuum Bag
Note: The vacuum bag is located in
the base of the unit.
The vacuum bag full indicator light
will go on to indicate that the bag is full
and needs to be replaced. To replace
the bag perform the following steps:
1. Unplug unit.
2. Lift off the outer metal enclosure
from the base of the unit.
3. Remove the vacuum bag cover.
(Fig. 7)
Fig. 7
4. Press on the vacuum bag release,
in order to release the bag and
remove it. (Fig. 8)
Vacuum Bag
Release Button
Fig. 8
5. Remove the vacuum bag from the
vacuum bag holder. (Fig. 9) The
vacuum bag should slide out easily
from the vacuum bag holder. Put
the dirt and dust filled vacuum bag
in the garbage bin.
6. Take a new vacuum bag and
attach it to the vacuum bag holder
by sliding the vacuum bag’s
cardboard front into the grooves of
the vacuum bag holder. It should
slide in easily. (Fig. 10) DO NOT
REUSE THE VACUUM BAG.
Fig. 10
Slide
vacuum
bag holder
upwards
Vacuum
Bag
Holder
7. Press on the vacuum bag release,
and align the hole on the vacuum
bag holder with the suction intake
hole under the vacuum bag
release button. Once aligned and
in place, stop pressing the vacuum
bag release in order for it to remain
in place.
WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, THE POWER
CORD MUST BE DISCONNECTED BEFORE REMOVING
THE DUST BAG, THE PRE-MOTOR AND HEPA FILTER, OR
PERFORMING MAINTENANCE AND TROUBLE SHOOTING
CHECKS.
WARNING: NEVER OPERATE THE VACUUM WITHOUT THE
VACUUM BAG AND ALL THE FILTERS IN PLACE.
7
Fig. 9
Slide
vacuum
bag holder
upwards
Vacuum
Bag
Holder