Electrolux PE 8036-M - Manual (Page 19)

19
· Every month wash the filter and
filter holder in the dishwasher.
· The steam nozzle (A-2) should be
periodically cleaned. It could
become dirty inside by making
cappuccinos. It should be
removed (N/1,N/2) and washed
with a sponge in warm water.
Attention: Before cleaning the
steam pipe, always turn the
machine off and wait at least
20 minutes after use to allow
the steam pipe to cool. This
will avoid the risk of burns.
WATER RESERVOIR
· If the machine is not be used for
long periods, change the water in
the reservoir and empty the boiler
by pushing the coffee button (B-
21) as many times as necessary.
· Periodically clean the water
reservoir(A-9) to remove the fur.
· The water reservoir can be
washed in a dishwasher.
· The Brita filter should be replaced
after approximately 2000 cups of
coffee or at least after six months.
BOILER CLEANING CYCLE
· Like all the appliances that use
water, it is possible that fur will
appear in the boiler of the coffee
machine.
· Every six months the following
process should be carried out:
- Fill up the water reservoir with 1,5
litres of water also adding half a
glass of vinegar or citric acid.
- Dispense some coffee (see
paragraph 6. Coffee), but without
using either ground coffee or
pods, so that only water will come
out of the filter holder until the
reservoir is completely empty.
- Fill the reservoir again with cool
clean water and repeat the above
process (without using coffee as
before) in order to rinse the
boiler.
- The coffee machine is now ready
for use.
12. INSTALLATION
INSTALLING THE MACHINE INTO
FURNITURE HOUSING
For the machine to operate correctly,
it must be installed into a suitable
housing unit.
In conformity with safety norms, the
protection to avoid contacts with the
electrical parts and the parts protected
only with functional insulation should
be guaranteed by a correct insertion of
the appliance.
All components that guarantee
protection, even a cover panel (if the
appliance for example is situated at
one extremity of the modular
furniture), should be well fastened so
that they can not be removed without
using tools.
The appliance should be installed at a
certain distance from refrigerator or
freezer, because the heat given out
from it can impair their functioning.