Electrolux PE 8036-M - Manual (Page 21)

21
INSTALLATION WITH SUPPORT
· Put the suitable plates (P/1,P/2)
on both sides of the cabinet sides,
fixing them with the double-
sticker strips (R/1)
Pay attention to the position
of the bevel which indicates
the right position of the
plates.
· Release the telescopic runners
and extract the front section (R/2)
· Fix the telescopic runners’
bearings with the screws as
shown in picture (R/3)
· Put the lock bracket in the correct
position and fix it with two self-
threading screws onto the base as
shown in picture R/4,R/5.
· Install the telescopic runners on
the both sides of the machine as
shown in picture R/6
· Insert the machine: the telescopic
runners should be coupled with
the runners ‘ bearings which are
already fitted on the sides. (R/7).
· Ensure the safety lock operates
when the runners are pushed in.
· With the machine completely
inserted in the housing use the
cabinet locking button (A-6) and
check that it functions correctly.
· Adjust the cabinet locking bracket,
if necessary and secure as shown
in picture R/8
· Push the cabinet locking button so
that the machine will be correctly
fastened (F/2).
WATER CONNECTION
· Push the cabinet locking button
(E/1) .
· Take the coffee machine out of
the cabinet using the special
telescopic runners (E/2)
· Remove the lid of the water
reservoir (A-9), and take the Brita
filter out (A-17)
· Remove its packaging and soak
the filter in cool water for half an
hour; then, insert it into the
reservoir (S/1)
· Insert the flexible suction water
pipe (the one with the filter) and
the ventilation pipe in the special
grooves (S/2). Push the pipes into
the reservoir end-plate (S/3)
· Fill up the reservoir with cool
water
· Attention: Only fill the reservoir
with cool drinking water: under no
circumstances put milk or other
liquids!
· Brita filters can be purchased from
our Service Centres, retailers of
electric household appliances or
retailers of this type of spare
parts.
13. WHAT TO DO IF….
If your machine does not function,
please ensure that the fault is not
caused by:
1. A power failure
2. The water reservoir being empty.
If you require a replacement power
cable or if your machine requires
servicing, please contact your local
Service Force Centre.