Recommended grounding method, Leveling the ice maker, Reversing the door swing – EdgeStar IB450SS User Manual

Page 12

Advertising
background image

Before you move your icemaker into its final location, it is important to make sure you

have the proper electrical connection:

A standard electrical supply (115 V, 60Hz.), properly grounded in accordance with the

National Electrical Code and local codes and ordinances, is required.

It is recommended that a separate circuit, serving only your icemaker, be provided. Use

receptacles that cannot be turned off by a switch or pull chain.

The fuse (or circuit breaker) size should be 3 amps.

Recommended grounding method

For your personal safety, this appliance must be grounded. It is equipped with a power
supply cord having a 3-prong grounding plug. To minimize possible shock hazard, the
cord must be plugged into a mating 3-pronged and grounding-type wall receptacle,
grounded in accordance with the National Electrical Code and local codes and ordinances.
If a mating wall receptacle is not available, it is the personal responsibility of the
customer to have a properly grounded, 3-prong wall receptacle installed by a qualified
electrician.

Leveling the Ice Maker

It is important for the icemaker to be leveled in order to

work properly. It can be raised or lowered by rotating

the plastic sheaths around each of the four feet on the

bottom of the machine .If you find that the surface is

not level, rotate the feet until the ice maker becomes

level .You may need to make several adjustments to

level it. We recommend using a carpenter’s level to

check the machine.

1.Place a carpenter’s level on top of the product to see if the ice maker is level from front

to back and side to side .

2.Adjust the height of the feet as follows:

Turn the leveling feet to the right to lower that side of the ice maker

Turn the leveling feet to the left to raise that side of the ice maker .

IMPORTANT: Once you are ready to install it in a cabinet or directly on the floor, you
must adjust the feet to level the ice maker. If the floor is level, just revolve the two front
feet to touch the floor.



Reversing the Door Swing

Tools needed: flathead screwdriver, Phillips screwdriver
IMPORTANT: Before you begin, unplug the ice maker or disconnect power.

12

Advertising