For your safety read before operating, Lighting instructions – Empire Products FAW-55IP User Manual

Page 10

Advertising
background image

12429-10-0408

Page 10

FOR YOUR SAFETY READ BEFORE OPERATING

WARNING: If you do not follow these instructions exactly, a fire or explosion may result

causing property damage, personal injury or loss of life.

A. This appliance is equipped with an ignition device which

automatically lights the pilot.

Do not try to light the pilot by hand.
B. BEFORE OPERATING smell all around the appli-

ance area for gas. Be sure to smell next to the floor

because some gas is heavier than air and will settle on

the floor.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electrical switch;

Do not use any phone in your building.

• Immediately call your gas supplier from a neighbor’s

phone. Follow the gas supplier’s instructions.

• If you cannot reach your gas supplier, call the fire

department.

C. Use only your hand to push in or turn the gas control

knob. Never use tools. If the knob will not push in or

turn by hand, don’t try to repair it; call a qualified

service technician. Force or attempted repair may

result in a fire or explosion.

D. Do not use this appliance if any part has been under

water. Immediately call a qualified service technician

to inspect the appliance and to replace any part of

the control system and any gas control which has

been under water.

1. STOP! Read the safety information

above.

2. Set the thermostat to lowest setting.
3. Turn off all electric power to the appliance.
4. This appliance is equipped with an ignition

device which automatically lights the pilot. Do not try

to light the pilot by hand.

5. Remove control access panel (lower front panel).
6. Turn gas control knob clockwise

to

“OFF.”

7. Wait ten (10) minutes to clear out any gas.

Then smell for gas, including near the floor. If you smell

gas, STOP! Follow “B” in the safety information above.

If you don’t smell gas, go to the next step.

8. Turn gas control knob counterclockwise

to “ON”.

9. Replace control access panel (lower front

panel).

10. Turn on all electric power to the appliance.
11. Set thermostat to desired setting.
12. If the appliance will not operate, follow the instructions

“TO TURN OFF GAS TO APPLIANCE” and call your

service technician or gas supplier.

TO TURN OFF GAS TO APPLIANCE

OPERATING INSTRUCTIONS

1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance

if service is to be performed .

3. Remove control access panel (lower front

panel).

4. Turn gas control knob clockwise

to “OFF.” Do not force.

5. Replace control access panel (lower front

panel).

LIGHTING INSTRUCTIONS

Advertising