Epson MediaLink Controller MLC 104 IP Plus - Manual (Page 22)

MLC 104 IP Plus • Software Setup
Software Setup, cont’d
3-16 MLC 104 IP Plus • Software Setup 3-17
Control module main window
4 . Select the Address #1 tab. The Address 1 IRCM-DV+
[DVD] window appears.
5. In the upper left corner drop-down menu (under
DVD & VCR Control ), select Input 2, as illustrated below.
This assigns the input button (Input 2) to activate the
IRCM-DV+ [DVD] control panel.
Input 2 button selection
6 . Click the Auto Fill button.
N You must have added an applicable IR driver to use
Auto Fill.
A dialog box appears.
Control module configuration
7 . From the Auto Fill Dual-Function DVD and VCR IR
Control Module dialog box, select the Hitachi DV-PF7E
DVD/VCR IR driver. All functions for the selected driver
appear in the right side pane of the dialog box.
8 . Select Port A from the bottom portion of the dialog box.
9 . Click the OK button. The dialog box closes.
All commands that match a button on the module are
assigned to that button. Red triangles on the buttons of the
control module indicate that all the matching buttons have
been auto-filled.
10 . To configure Address 2 IRCM-DV+[VCR], repeat steps 1
through 9, substituting Address 2 for Address 1.
N In step 5, you will need to select a different input button in
the VCR half of the control module.
N If using an IRCM-DV+, you must associate each half with
an input.