EnGenius Technologies EnGenius 11b/g Wireless SOHO Router 1.2 - Manual (Page 23)

23
WAN Settings – Static IP
ƒ Click on the WAN link on the navigation drop-down menu. This feature allows you to
configure the WAN interface using a static IP address, DHCP Client, PPoE, or PPTP.
ƒ WAN Access Type: Select Static IP from the drop-down list. This type of connection
is used when your ISP has provided you a dedicated IP address.
ƒ IP Address: Enter an IP address for this device, which is assigned by your ISP.
ƒ Subnet Mask: Enter the subnet mask for this IP address, which is assigned by your
ISP.
ƒ Default Gateway: Enter the IP address of the default gateway, which is assigned by
your ISP.
ƒ MTU: You may adjust the Maximum Transmit Unit (MTU), however it is recommend
that this value is set to the default: 1500 bytes
ƒ DNS 1-3: Specify the IP address of the DNS server
ƒ Clone MAC Address: Specify a MAC address if you would like to use a different
MAC address on this device. (optional)
ƒ Enable uPNP: Place a check in this box to enable UPnP. It is recommended to
enable this feature as it’s used by several applications.
ƒ Enable PING Access on WAN: Place a check in this box if you would like the device
to be pinged from the WAN side (ISP).
ƒ Enable Web Sever Access on WAN: Place a check in this box if the static IP
address if used for a web-server.
ƒ Enable IPsec pass through on VPN connection: Place a check in this box to
enable the pass through of IPsec packets on a VPN connection.