EnGenius Technologies EnGenius 11b/g Wireless SOHO Router 1.2 - Manual (Page 26)

26
ƒ Connection Type: Select Continuous (always online), Connect on Demand
(connect to the ISP only when you click on a website), or Manual (connect to the ISP
only when you click on a ‘Connect’ button) from the drop-down list.
ƒ Idle Time: The PPPoE service can automatically disconnect if the connection is idle.
Specify the number of minutes after between 1 and 100.
ƒ DNS: The ISP usually automatically assigns the DNS IP address, in case you need
to assign it manually then click on the Set DNS Manually and fill in the fields.
ƒ MTU: You may adjust the Maximum Transmit Unit (MTU), however it is recommend
that this value is set to the default: 1500 bytes
ƒ DNS 1-3: Specify the IP address of the DNS server
ƒ Clone MAC Address: Specify a MAC address if you would like to use a different
MAC address on this device. (optional)
ƒ Enable uPNP: Place a check in this box to enable UPnP. It is recommended to
enable this feature as it’s used by several applications.
ƒ Enable PING Access on WAN: Place a check in this box if you would like the device
to be pinged from the WAN side (ISP).
ƒ Enable Web Sever Access on WAN: Place a check in this box if the static IP
address if used for a web-server.
ƒ Enable IPsec pass through on VPN connection: Place a check in this box to
enable the pass through of IPsec packets on a VPN connection.
ƒ Enable IPsec pass through on VPN connection: Place a check in this box to
enable the pass through of PPTP packets on a VPN connection.
ƒ Enable IPsec pass through on VPN connection: Place a check in this box to
enable the pass through of L2TP packets on a VPN connection.
ƒ Click on the Apply Changesto save the changes.
WAN Settings – PPTP
ƒ Click on the WAN link on the navigation drop-down menu. This feature allows you to
configure the WAN interface using a static IP address, DHCP Client, PPoE, or PPTP.