Electrolux LAVAMAT 62610 - Manual (Page 15)

15
Programme progress
• The programme progress display shows the programme step that is
currently being carried out.
–
(Prewash)
– (Main wash)
– (Rinse)
– (Extra Rinse)
– (Spin)
– (End)
• The multi-display shows the estimated time remaining (in hours and
minutes) until the end of the programme.
3
The remaining programme time may increase or briefly remain constant
during the wash programme as the programme adjusts to various con-
ditions while washing (e. g. type of washing, amount of washing, rec-
ognising out-of-balance when spinning, special rinse cycle, etc.).
Interrupting a programme/Adding washing
Interrupting a programme
• A washing programme can be interrupted at any time by pressing the
button (START/PAUSE) and then re-started by pressing the
button (START/PAUSE) again.
• To stop the washing machine before the programme has ended, turn
the programme knob to (OFF). Important: Be careful if there is
water in the appliance!
Adding washing
It is possible to add washing, as long as the
(DOOR) light is lit green.
1. Press the button (START/PAUSE). The door can be opened.
2. Close the door and press the button (START/PAUSE) again. The
programme will continue.
End of the wash cycle/Removing the washing
When the programme has finished, (END) will illuminate on the pro-
gramme progress display. The door can be opened as soon as the in-
dicator (DOOR) is lit green.
1. Open the door and remove the washing.
2. Turn the programme knob to
(OFF).
3. Close the water tap.