Electrolux LAVAMAT 16810 - Manual (Page 51)

Water inlet (cold water connection only)
Connect the hose
to a tap with a
3/4” thread.
Installation
should comply
with local water
authority and
building regula-
tions’ require-
ments.
Model 16810
The inlet hose is provided with a water stop device, which protects
against damage caused by water leaks in the hose which could develop
due to natural ageing of the hose. This fault is shown by a red sector in
the window “A”. Should this occur, turn the water tap off and refer to
your Service Force Centre to replace the hose.
Set the hose correctly by loosening the ring
nut. After positioning the inlet hose, be sure
to tighten the ring nut again to prevent
leaks.
Do not connect to a hot water supply.
Water drainage
The appliance drain hose should hook into a
standpipe, the hook in the drain hose is
formed using the plastic “U-
Piece” supplied. The standpipe
should have an internal diame-
ter of approximately 38 mm (see
diagram on page 52) thus ensur-
ing there is an air break between
the drain hose and standpipe.
When discharging into a standpipe ensure that the top of the curve in
the hose end is no more than 90 cm (35.4”) and no less than 60 cm
(23.6”) above floor level.
51
Installation
A
3 pin
Max. 90 cm.(35.4")
Min.60 cm.(23.6")
Model 16810 Model 14810
132994040.qxd 1/22/03 9:16 AM Pagina 51 (Nero/Process Black pellicola)