General information moving your cooker, Connecting to the electricity supply, For your safety – Electrolux 55G User Manual

Page 27

Advertising
background image

General information

Moving your cooker

You may damage some soft or badly fitted floor coverings when you
move the cooker. The floor covering under the cooker should be
securely fixed so it does not ruck up when you move the cooker across
it. Alternatively you could remove the floor covering.

To move the cooker open the oven door and slide out the oven roof

liner. Raise the cooker off its front feet by lifting from inside the oven.
Pull the cooker forward. When you replace the cooker push it back to
the stop and make sure there is the same gap at each rear corner.

Connecting to the electricity supply

The plug supplied with the cooker can be fitted directly to a suitable
three pin earthed socket.

If you have to change the fuse replace it with a 3 amp fuse which

has been ASTA approved to BS 1362.

Do not use the plug until you have put the fuse cover back on. If the

fuse cover is lost you can get a replacement from an electrical retailer.
The correct replacement can be identified by marking or colour coding.

If you cut the plug off dispose of it safely as it will be a shock hazard

if it is inserted into a 13 amp socket elsewhere in the house.

L Y R I C 5 5 G

27

For your safety

Do not block any of the cooker vents.

Never line any part of the cooker with aluminium foil.
Don't let items which can catch fire or electric mains leads

such as kettle flexes trail over any part of the cooker.

For your safety

This cooker must be earthed and protected by a 3 amp fuse.

General information

Advertising