Eiki EIP-250 - Manual (Page 23)

21
Before connecting, ensure that the power cord of the projector is unplugged from the AC
outlet and turn off the equipment to be connected. After making all connections, turn on the
projector and then the other pieces of equipment. When connecting a computer, ensure that
it is the last equipment to be turned on after all the connections are made.
IMPORTANT:
Ensure that the appropriate input mode has been selected on the projector before
you turn on the connected equipment.
• For more details of connection and cables, refer to the owner’s manual of the connecting equipment.
• You may need other cables or connectors not listed below.
Connecting the Projector to Other Equipment
COMPUTER/
COMPONENT
Equipment
Computer
Cable
Terminal on
connected equipment
Terminal on the
projector
RGB
output
terminal
RGB cable (supplied)
DVI-I
DVI digital
output
terminal
DVI Digital cable (commercially available)
mini D-sub 15 pin to DVI cable
(commercially available) RGB
output
terminal
is only for EIP-2600.
Terminals on the Projector
Note
• See page 62 “Computer Compatibility Chart” for a list of computer signals compatible with the projec-
tor. Use with computer signals other than those listed may cause some of the functions to not work.
• A Macintosh adaptor may be required for use with some Macintosh computers. Contact your near-
est Macintosh Dealer.
• Depending on the computer you are using, an image may not be projected unless the
computer’s external output port is switched on. Refer to the specific instructions in your computer
owner’s manual to enable your computer’s external output port.
Example: Terminals of EIP-2600