Extron electronic MLS 103 V - Manual (Page 3)

MLS 100 Series• Quick Start Guide
To install and set up the MLS 100 Series switchers, follow these steps
and see the appropriate section of this manual for details:
Step 1
Turn all of the equipment off and disconnect the power cords.
Step 2
Mount the switcher (if applicable) or affix the rubber feet to the
bottom of the switcher for tabletop use. See page 2-2.
Step 3
Attach the cables. See the instructions beginning on page 2-5.
MLC 206
Bottom Panel
NOTE Ground all devices. If you use
cable that has a drain wire, tie the
drain wire to ground at both ends.
To connect a computer or third
party control system, see page 2-8.
1 2
OUTPUT INPUTS
MLS 102 VGA
L R
A B
L R 1 2 3 L R 4 AUX/MIX MONO
AUDIO INPUTS OUT CONTROL/
POWER
12V .5A MAX
MLS 102 VGA
A B C D E A B C
IR
Display/Source Control Extron Switcher Control Relays IR / RCM
RS-232
D E A B C A B D 1A 1B 2A 2B 3A 3B 1 2 3 4 5 6
Tally Out MLS/Power
33-644-01 A 07 01 Pr
inted in the USA
Balanced/
Unbalanced
Output
Amplifier
Unbalanced,
Stereo Input
Balanced/Unbalanced,
Mono Aux. Input Wireless
Microphone's
Receiver
VCR
Projector
Laptop
External
Power Supply
For the Aux/Mix Mono audio input, connect a 3.5 mm,
3-pole captive screw connector to one end of an audio
cable as shown at right. This line level input can be
balanced or unbalanced. Wire the other end to one
tip-ring-sleeve connector.
The Aux/Mix level must be
adjusted
(-43dB to +24dB) via the
front panel control . It cannot be
adjusted via software.
Aux/Mix Input Wiring
(balanced/unbalanced, mono)
AUX/MIX
MONO
Tip (+)
Ring (–)
Gnd (Sleeve, )
Quick Start Guide — MLS 100 Series
QS-1