Extron electronic MLS 103 V - Manual (Page 6)

MediaLink VersaTools Switchers • Introduction
Introduction
MediaLink ™ VersaTools ™ Switchers
2
Chapter Two
Installation
UL/Safety Requirements
Mounting the Switchers
Rear Panel Features and Cabling
Setting Up Optimal Audio Gain
Application Diagrams
About this Manual
This manual contains information about the Extron MLS 100
Series Switchers (MLS 100 A, MLS 103 V, MLS 103 SV,
MLS 102 VGA) and on how to install, set up, and operate them.
“MLS 100 Series switcher”, “MLS”, and “switcher” will be used
interchangeably in this manual.
About the MLS 100 Series Switchers
The Extron MLS 100 Series Switchers are compact, quarter rack
width switchers. The MLS 102 VGA, MLS 103 SV, and
MLS 103 V have a 250 MHz (-3dB) video bandwidth. The
MLS 102 VGA, MLS 103 SV, and MLS 103 V provide a way to
switch up to three video input signals (up to two for the VGA
model) to one output.
All models (MLS 102 VGA, MLS 103 SV, MLS 103 V, MLS 100 A)
feature four selectable audio inputs, and also one Aux/Mix
input that is always active and can be mixed with any and all of
the four selectable audio inputs.
Front panel buttons, an RS-232-based control system, or an
Extron MediaLink
™ Controller (MLC) can be used for input
selection.
Features
Furniture, rack, and projector mountability — MLS 100 Series
Switchers can be mounted under a desk or other
furniture, or mounted on a projector lift with optional
brackets. Alternatively, they can be rack mounted on an
optional rack shelf.
Stereo audio input and output — Unbalanced stereo audio
inputs can be output as balanced or unbalanced stereo
audio, and the audio output level can be adjusted.
Mono auxiliary/mix audio input — The Aux/Mix port on each
switcher lets you mix a mono, line level audio input
signal with that of one of the four selectable stereo audio
inputs.
1-2