Electrolux 86720 - Manual (Page 28)

Operating Instructions
28
What to do when
3
The whistling noise when spinning may be different to
your prevous washing machine which is due to the
modern drive system.
Trouble Shooting
If you call out an engineer and the fault is listed here, a charge is levied
even if the appliance is in guarantee.
• If the error code (1, (2 or (d is displayed in the multi-display, check
the troubleshooting guide below before calling an engineer.
After eliminating the error, press the START/PAUSE button. If the
error code is displayed again, please contact your local AEG Service
Force Centre
• For all other errors displayed in the multi-display, please contact your
local AEG Service Force Centre, stating the error code.
Malfunction Possible Cause Remedy
Washing machine does
not work.
Mains plug is not plugged in. Insert mains plug.
House fuse in defective.
Replace fuse.
Door is not closed properly.
Close door; lock must engage
audibly.
START/PAUSE button not
pressed long enough.
Keep START/PAUSE button
pressed until the program
starts.
No water flows in.
Error code (1 appears.
Tap is closed. Open tap.
Filter in the threaded fitting
on the water inlet hose is
blocked.
Unscrew the hose from the
tap, remove the filter and
clean under running water.
Error code (d appears
Door is probably not closed
properly.
Close the door again. Press
the door firmly in the area of
the lock.