Electrolux 86720 - Manual (Page 29)

Operating Instructions
29
Washing machine
vibrates during opera-
tion or is unstable.
The machine is not level.
Adjust the feet according to
the installation and connec-
tion instruction.
There is only very little wash-
ing in the machine (e.g. only
a bath robe).
Does not impair function.
Water could not be com-
pletely pumped out prior to
spinning because
the drain hose is kinked
or
the drain pump is blocked.
Check the drain hose and if
necessary remove any kink or
clean the drain pump and
remove any foreign bodies
from the pump housing.
Excessive foaming dur-
ing the main wash.
Probably too much detergent
was used.
Dose detergent exactly in
accordance with the manu-
facturer’s instructions.
Water runs out from
under the washing
machine.
Threaded fitting on the
water inlet hose is leaking.
Tighten the inlet hose con-
nections.
The inlet hose has a leak.
Check the inlet hose and if
necessary replace it.
The drain pump cover is not
tight.
Tighten cover by turning
clockwise.
Washing is caught in the
door.
Abort the program, remove
the washing caught in the
door, start a new program.
Fabric softener is not
added, compartment
À
for fabric softener
is filled with water.
Suction cap in the fabric sof-
tener compartment is not
correctly fitted or is blocked.
Clean detergent dispenser
drawer, place suction cap
firmly in position.
Washing has not been
spun sufficiently, there
is water left in the
drum.
Error code (2 appears.
Drain hose is kinked. Remove kink.
Maximum pumping height
(drain height 1m from the
position of the machine) is
exceeded.
Please contact the AEG Serv-
ice Force Centre, it has a
retro-kit available for pump
heights above 1m.
Drain pump is blocked.
Switch off the machine and
pull the plug out of the
socket, clean the drain pump.
The water drainage system is
blocked.
Clean the blockage.
Malfunction Possible Cause Remedy