EverFocus GIGABIT MANAGED ETHERNET SWITCH ESM316T002R - Manual (Page 6)

6
Logging In
Please follow the steps to configure this Web Smart switch. The configure procedure is as follows:
Step 1: Use Ethernet Category 5 cable to connect this switch to your PC.
Step 2: Check that your PC has an IP address on the same subnet as the switch. For example, the PC and the
switch are on the same subnet if they both have addresses that start 192.168.1.x. The subnet mask is
255.255.255.0.
Step 3: Open the browser (like Microsoft Internet Explorer) and go to http:// 192.168.1.1, which is the switch
address, for example. If your PC is properly configured, you will see the login page like below:
Figure 2: Login Popping Up Window
NOTE: If you do not see the login page, check step 1 & 2.
Step 4: Please key in both the default user name “admin” and the password “admin” to pass the authentication.
After the authentication procedure, the switch can be used now, as the web home page appears as follows: