Eicon Networks 1551 - Manual (Page 4)

4
Changes to settings are made through a web browser. The
web pages reside on the Eicon 1550/1551 itself.
1. Launch your web browser.
2. Click ‘File’, ‘Open’, then enter the following IP address:
192.168.1.1
3. Click ‘OK’. You should see the ‘Log in’ page.
Note: If you receive an error message from your browser, and you
cannot access this web page, see ‘If you cannot access the
Eicon 1550/1551 Log in page’ on page 7.
4. Click the ‘Log in’ button.
By default there is no password.
5. The main menu should appear, as shown below.
6. To continue, see ‘Step 3: Select the VHSI Protocol’ on
page 4.
Settings for particular connections are contained in profiles
on the Eicon 1550/1551. However, before you begin creat-
ing connection profiles, including any backup profiles, you
should verify the protocol setting for the VHSI port (set to
‘X.25’ by default). This is due to the fact that all connection
profiles are deleted when the protocol is changed.
Note: Configuration settings can be saved to a file on your hard drive. This
is useful if you have many connection profiles already defined but need to
change the VHSI protocol. See the User’s Guide for more information.
To select the VHSI protocol:
1. From the menu at the left of the screen, click on the small
‘+’ next to ‘VHSI Port’ to expand the VHSI Port group,
then click the ‘Protocol’ link.
2. From the ‘Protocol’ drop-down menu, select a protocol.
3. If you changed the protocol, click the ‘Save’ button,
located at the bottom right of the web page, when
finished. You may have to scroll down in order to locate
the button.
Note: If you do not click ‘Save’, any changes will be lost when you
move to another page.
Step 2: Access the Configuration Pages Step 3: Select the VHSI Protocol
‘Protocol’ link
‘Protocol’
menu