EdgeStar PAC8000S - Manual (Page 8)

.
Maintenance
Maintenance and Storage
if
,
1. If you are not going to use this unit for a long time, be sure to drain the water from the
reservoir by removing the drain cap and the rubber plug.
2. Before storing the unit, run it in fan mode for a few hours to dry any moisture on the coils to
prevent mold.
3. Turn the unit off, clean the air filter and reinstall it.
4. Remove the exhaust hose and connectors and keep them in a safe place.
It is necessary to clean or replace
the air filters periodically.
Clean as follows:
Wipe with a soft
dry cloth.
Replace the activated carbon filter
The activated carbon filter cannot be cleaned
and needs to be disposed of when cleaning the
pre-filter. EdgeStar sells replacement activated carbon
filters. Contact customer service via email at
[email protected] or by telephone at
1-866-319-5473 to purchase additional activated carbon
filters.
T urn off the appliance
first before disconnecting
from the power supply.
Use lukewarm water
(below 104˚F) to clean
the appliance.
Never spray water onto the main
unit.
Never use volalile substances such
as gasoline or polishing powder to
clean the appliance.
Stop the appliance and remove
the activated carbon filter and the
pre-filter.
The activated carbon
filter attaches to the
standard pre-filter. The
activated carbon filter
removes smoke, odors
and other harmful
particles, while the
pre-filter removes dust.
Clean and reinstall the pre-filter
Dirt can be cleaned off the pre-filter
by cleaning it with a solution of soap in
lukewarm water. After cleaning the pre-filter,
allow it to air dry in shaded and cool place, then
reinstall. Clean the pre-filter
every two weeks if the air
conditioner operates in a
dusty environment.