Epson PL 735c - Manual (Page 24)

24
You see the following screen:
6. For Mail Notification Settings, select ON and press Enter on the
remote control.
7. Highlight the IP address of SMTP server box and press Enter .
The outline of the box turns green to indicate you are in input
mode. You can enter numbers between 0 and 255. However, you
cannot use the following IP addresses: 255.255.255.255,
224.0.0.0, or 127.x.x.x (where x is a number between 0 and 255).
8. Highlight the Port Number box and press Enter . Then enter the
SMTP server port number. The default value is 25, but you can
enter numbers between 1 and 65535.
9. Highlight the box for Destination address 1 and press Enter .
Enter the e-mail address for the first computer that you want to
receive e-mail alerts. You can enter a maximum of 53 single-byte
alphanumeric characters.
10. If you want to send e-mail alerts to one or two other computers,
enter addresses for those computers in Destination address 2
and Destination address 3 .
11. Select the conditions under which an e-mail alert will be sent.
note
Use the up and down
buttons on the remote
control to enter letters and
numbers. You will also see
punctuation marks, such as
a period (.) and symbols,
such as @. When you see the
letter or symbol you want,
press
Enter . Then press the
right arrow to move to the
next position. To correct a
mistake, press the left arrow
to return to the previous
position.
Bernslip.fm Page 24 Friday, December 12, 2003 3:02 PM