EdgeStar DWP60ES - Manual (Page 20)

EdgeStar Dishwasher 16
Troubleshooting
Follow the troubleshooting guide below to resolve common issues.
Issue Possible Cause Solution
Fuse is blown or
circuit breaker is
tripped Replace fuse or reset
circuit breaker. Remove
any other appliances
sharing the same circuit
with the dishwasher.
Power Supply is
not turned on Ensure the dishwasher is
turned on and the door is
closed securely.
Make sure the power cord
is properly plugged into
the wall socket.
Dishwasher does not
start
Dishwasher door is
not properly closed Close dishwasher,
ensuring that the door
latches.
Kink in drain hose Check drain hose
Filter clogged Check coarse filter
Water not pumped
from dishwater
Kitchen sink
clogged Ensure kitchen sink is
draining well. If sink is not
draining refer to a
plumber.
Improper detergent Use only the specified
detergent. If improper
detergent was used, open
the dishwasher allowing
suds to evaporate. Add 1
gal. of cold water to the
tub. Close and latch the
door. Start the “SOAK”
wash cycle to drain the
water. Repeat if
necessary Suds in tub
Spilled rinse-aid Always clean up rinse-aid
spills immediately.
Stained tub interior Detergent used
contained colorant Do not use detergents
with colorants.
White film on
dishwasher interior
surface Hard water
minerals While wearing rubber
gloves, use a damp
sponge to clean the
interior with dishwasher
detergent. Never use any
other cleaner to clean
dishwasher.
Rust stains appear on
cutlery Items are not non-
corrosive. Do not place non-
dishwasher safe items in
dishwasher.