EverFocus SPEED DOME EPTZ900 - Manual (Page 25)

2-24
2.4.3. EPTZ500 Dome Camera Installation
1. Take off the housing from the packing, and take off he PCB board (4 bolts on it) inside
the housing.
2. Cut the ceiling against the housing’s shape with a saw.
3. Thread the cable through the screw and the hole on the top of the housing, and tighten
up the screw to fix the cable
4. Place the housing into the hole that you just made. Fix the housing on the ceiling with
two clips, adjust the screws of clips to make the housing perfectly fit to the ceiling.
5. Connect the cable connectors to the nodes on the base board, and then fix the base
board in the housing by screwing 4 bolts on it.
RELAY JP5
V
ideo +
V
ideo -
R
S
4 85 +
R
S
4 85 -
AC
2 4
AC
2 4
Cut the ceiling