EPOS ELS Series - Manual (Page 2)

Some experimentation may be
necessary to establish the ideal
position within your listening
room. Begin by positioning the
loudspeakers about 20cm (8”)
from the rear wall and gradually
move them out a little until you
achieve the best balance
between bass weight and
definition. Avoid placing the
loudspeakers in corners because
this may cause un-welcome
colouration of the midband
frequencies. Try to leave at least
40cm of space between each
loudspeaker and the nearest side
wall.
The optimum stereo performance
will be achieved when the
speakers are positioned 2.5
metres (8’) or more from the
listener and about the same
distance from one another.
Turning the speakers in very
slightly towards the listener often
helps to stabilise the stereo
image.
Speakers ‘image’ best if you can
just see the top face of the
speaker from your listening
position. Remember, there is no
absolute right or wrong - if it
sounds good, it is good.
The best results will be obtained
from the ELS 3 if they are placed
on stands rigidly coupled to the
floor using carpet piercing spikes.
This will help preserve the
outstanding midband clarity
which is a hallmark of Epos
loudspeakers.
Epos stands are available to
match the ELS 3. Please contact
your dealer for further information
or visit the Epos web site:
www.epos-acoustics.com
Ensure that your amplifier is
switched off before you make or
break any connections, as
damage may occur if shorted.
Your Epos loudspeakers are
equipped with high quality
connection sockets with excellent
electrical contact and current
specification.
A set of 4 plugs is supplied with
your loudspeakers. These will
allow you to terminate your
speaker cables. To terminate the
cables, simply remove enough
insulation to allow the plastic
STANDS
CONNECTION