Emerson ES27 - Manual (Page 9)

8
LISTENING TO RADIO
OPERATION
1.) Press the POWER button to turn the unit ‘On’.
2.) Select the Tuner function by pressing the TUNER button.
3.) Select the desired band (AM or FM) with the BAND button.
4.) Tune to the desired radio station by pressing the TUNING UP or DOWN
buttons on the unit or on the remote control.
5.) If you hold the TUNING UP or DOWN button for more than half a second
the Tuner will begin to automatically scan until a strong signal is found.
6.) To turn off the radio, press the POWER button to switch the unit into standby
mode.
STORING PRESET STATIONS
1.) Tune either automatically or manually (as described in steps 4 or 5 above) to
the station to be stored.
2.) Press the PROG / MEMORY button once.
“MEMORY” will flash in the display for 5
seconds. During this time you must select
the desired memory location by pressing
the REPEAT / MEMORY UP button.
3.) Press the PROG / MEMORY Button again
to store the station at that location.
4.) The unit can store up to 20 FM stations, 20 AM stations.
TUNING TO A PRESET STATION
Select the desired station preset number by pressing the REPEAT / MEMORY UP
button.
MHz
FM
POP
MEMORY CH STEREO
MHz
FM
POP
CH STEREO
ES27_ib_drafts.p65 19/3/2002, 16:09 8