Extron Electronics MLC 206 - Manual (Page 3)

3
3. To power the MLC, connect a 12 VDC power supply or an optional
MediaLink Switcher (MLS) to the MLS/Power port, and connect the power
supply or the switcher to a power source.
MediaLink Switcher
MLC/RS-232
A B
MLC 206 powered by a MediaLink Switcher
Connecting an MLC 206 to an external power supply
MLC 206
MLS/Power
port
MLC
MLS/Power
port
A B
MLS / Power
Ground ( )
+12 VDC input
0 A ground wire must be connected
between the MLC and MLS.
Ground ( )
+12VDC
Transmit (Tx)
B Receive (Rx)
A
A B
MLS / Power
Transmit (Tx)
Receive (Rx)
+12VDC
Ground ( )
B
A
Ground all devices
An external
power supply
(12 VDC, 1 A max.)
Step 2 — Software Installation
The MLC must be configured before it can send commands to the projector or other
devices. Install the MediaLink Control Program software on the host PC. To install
the software, run SETUP.EXE from the Extron‑provided disk. Follow the instructions
that appear on the screen.
N The software is also available at
www.extron.com .