Mlc 206 setup guide, cont’d, Step 3 — setting up projector control – Extron Electronics MLC 206 User Manual
Page 4
MLC 206 Setup Guide, cont’d
4
Step 3 — Setting up projector control
Device drivers allow the MLC 206 to control projectors and other source devices via
RS‑232 or IR.
N It is strongly recommended that an RS-232 control (filenameRS1.mll) file for
controlling a projector be used whenever possible.
To load a driver and configure the MLC 206:
1
. Start the MediaLink Control Program.
The appearance of the screens varies depending on which
accessories (control modules and/or MediaLink Switcher)
are connected to the MLC, as shown in the following
pictures.
MLC 206 without accessories MLC 206 with an MLS switcher,
IRCM-DV+, and RCM-SC connected
2. Load a projector driver:
select the third tab, Controller (MLC) Config, and
select the Load Extron Driver button, as shown in the following illustration.
Choose the appropriate projector driver (filename.mll) from the on‑screen
menu. If the projector brand and model are not listed, check the Extron Web
site to see if a new driver is available or enter user‑defined RS‑232 strings. See
“Advanced Projector Config” in chapter 4 of the User’s Manual for details.