Exabyte 1005911-003 - Manual (Page 10)

Page 10 of 12 1005911
7 Testing the library and resuming operation
b. Press [ENTER]. An informational message appears, then the following
screen appears.
c. Use the arrow keys to select LCD mode and press [ENTER]. The screen
shows the new selection.
4. From the operator panel keypad, press [MENU] to display the menus.
Press the down arrow key until “Demo Menu” appears, as shown below.
5. Press [ENTER]. The following screen appears.
6. Press the up arrow to display “Y.” Press [ENTER]. The following screen
appears.
7. Use the arrow keys to set the number of moves (the left and right arrow
keys move across the columns; the up and down arrow keys change the
numbers). Then press [ENTER].
Note: The default number of moves is 10. Exabyte recommends that
you perform at least 20 moves.
8. The library begins the demo and displays status messages. If you want
to abort a demo in progress, press [ESCAPE].
9. After the demo moves have successfully completed, press [STATUS] to
return to the main menu.
10. Return the control mode to SCSI by pressing [MENU] then pressing the
down arrow key until “Robot Mode” appears.
R o b o t M o d e ?
S C S I ↕
! D e m o
M e n u
U s e
D r i v e N ↑
0 0 0 0 0 1 0
← ↕ →
! R o b o t M o d e
L C D