Exabyte 1005911-003 - Manual (Page 4)

Page 4 of 12 1005911
2 Removing the tape drive
2 Removing the tape drive
If you are replacing an existing tape drive, follow the steps below to remove
the drive. If you are installing an additional tape drive, skip to
Section 3,
“Removing the drive’s service access cover,” on page 5 .
1. From the library’s back panel, disconnect the cables from the back of the
tape drive you plan to replace. If you are replacing a SCSI tape drive,
remove any terminator that might be installed on the drive.
2. Use a #2 Phillips screwdriver to release the two captive screws that
secure the tape drive carrier to the library.
Tape drive
SCSI connectors
SCSI Library
Tape drive
Fibre Channel
connector
Fibre Channel Library
Handle
Captive screws