Enviro Vented EG 28 B - Manual (Page 4)

4
DECIDING WHERE TO LOCATE YOUR STOVE
DIMENSIONS:
FIG. 1
Front Width: 22"/ 56cm
Rear Width: 22"/ 56cm
Height: 27-1/2"/ 70cm*
Depth
19"/ 48cm
(*not including vent coupling)
Shipping Weight: 210 lbs/95 kg
CLEARANCES:
A. Side wall to stove 10"/ 25cm
B. Rear wall to stove 4"/ 10cm
C. Combustible to stove Top 22”/ 56cm
D. Floor to stove 0"/ 0cm
E. Corner clearance 2"/ 5cm
F. Alcove depth 48"/ 122cm
Maintain sufficient clearances
for service and maintenance
FIG. 2
• The stove should be located out of traffic and away from furniture and draperies.
• The stove should have sufficient access for its safe operation and maintenance.
• Locate a position where the flue system of the stove can be properly installed without damaging the integrity
of the building. e.g. cutting a wall or ceiling joist.
• The stove can be installed on any standard flooring materials i.e. Wood, carpet or linoleum.
• Check stove and flue system clearance requirements.
• Locate the stove where it can be accessed by a gas supply line.
• Locate the stove in a large and open room that is centrally located in the house. This will optimize heat
circulation and comfort.
• As the stove is equipped with a convection fan, ensure that an electrical outlet is within 6ft. (1.8m) of the
stove.
• These stoves can be installed in bedrooms.
(IN CANADA: must be installed with a listed wall thermostat)
(IN USA: see current ANSI Z223.1 for installation instructions.)
• The flow of combustion and ventilation air must not be obstructed.